HomeLab Part 8: Cooling and AirFlow

In my last post I had a problem with the onboard 10GBit NICs. My assumption is that they were overheated and therefor failed. I read some blog posts of other blogger and some of them experienced the same issue much earlier.
Because of that I bought a Noctua NF-A14 FLX double pack in the hope I can reduce the temperature in my cases. I don’t know how hot the passive cooler of the 10Gbit adapter was but it was approx. over 70°C or higher.
To get the right position of the new fan I read through some article describing the correct air flow. I came across a really cool article from Tom’s Hardware which explains how to position a fan for optimal air flow. The following picture was taken from that article to explain what I have done.
psu-bottom-05-EN
My current build of the server was exactly as shown in the picture, except the fan at the top over the horizontal CPU cooler. I thought this fan doesn’t make any differents or only minimal.
I have checked the temperature sensor of the mainboard through IPMI before and after I installed the fan and these are the results:

NameTemp. °C (before)Temp. °C (after)Difference (%)
CPU Temp3931-20.51%
System Temp5042-16.00%
Peripheral Temp455828.89%
PCH Temp6555-15.38%
P1-DIMMA1 Temp5141-19.61%
P1-DIMMA2 Temp4939-20.41%
P1-DIMMB1 Temp4837-22.92%
P1-DIMMB2 Temp4836-25.00%
P1-DIMMC1 Temp4834-29.17%
P1-DIMMC2 Temp5035-30.00%

As you can see the results are pretty awesome. Installing the fan drops the temperature in almost every sensor by a minimum of 15%. Only the peripheral temperature went up. I can only explain it that I haven’t waited some time when the host was powered up before I took the snapshot of the sensors. The fans I have bought are not cheap but worth the money.
I hope that with the new fan the problem from this post will not occur anymore.

1 Response

  1. Amazingly accommodating post. This is my first time i visit here but I have bookmarked it. I found such an extensive number of captivating stuff in your blog. Keep it up.

Leave a Reply

Your email address will not be published. Required fields are marked *